Picking up from where we left off, I had decided that I needed to create a controlled curve in the panel that I was creating for the front part of the O/S boot floor. I felt I needed a slip roller, or something similar. Researching available tools it soon became apparent that cost was disproportionate, given that it was entirely possible that I would never need this tool again, and so a 'DIY' solution was required. A couple of hours on YouTube and a root through the scarp metal bin... I came up with a plan. I used a couple of scrap bearings salvaged from Mazda Bongo idler pullys, two Ikea desk legs and an old HiFi speaker stand. The bearings fitted perfectly into the ends of the desk legs, great, so I then fitted some bolts and washers through the centre go the bearings as spindles. On the other end of the legs I found a couple more bolts that fitted snuggly into the plastic feet. Obviously not a robust solution, but I figured strong enough to last the short time required. I ...
After more than 20 years lying buried and forgotten in a damp and dusty garage, my 1970 Volvo Amazon has been dragged out into the light. But will it ever play the guitar again?